Mounting Press

Mounting press

1.Product Introduction of Mounting press

The Mounting press is a flexible mounting press, with modular mounting unit design, and is combined with one base unit and 1 - 5 mounting units. Meet the different customer's specific needs. The mounting press is suitable for the sample preparation of metallographic cold mounting, especially for epoxy or acrylic cold mounting. Without bubbles and pores samples can be made by putting them into the chamber and curing under pressure, physical and chemical properties of the resin will not change.

2.Product Parameter (Specification) of Mounting press

Voltage	10/220V
Heating Power	1.6kw
Mold Size	<t>30mm(standard),<i>25.4mm,032mm,040mm,<i>50mm(Customized)
Heating Range	60~2501
Holding Time	60 min
Maxpressure	570 Bar (Depending on mold size)
Pressure Mode	Hydraulic
Control Panel	7-inch touch screen	Push buttons
Cooling Mode	Auto:by temperature or time
Cooling rate	Manual/High/Middle/Low
Depth*With*Height	561*300*492mm	550*254*492mm
Weight	60kg	52kg

3.Product Feature And Application of Mounting press 

1、Modular design of mounting unit to meet customer’s specific needs;
2、Sliding closure with automatic open/close;
3、7-inch touch screen with max. 20 commonly procedures;
4、Pre-heating and per-press function to meet the specific mounting requirement of different material;
5、Real-time display the temperature and pressure curve during curing;
6、Individual control of heating/pressing/cooling for every unit.

4.Product Details of Mounting press

1、7-inch HMI, Friendly and simple user interface design;
2、Automatic water cooling, with three modes of cooling rate;
3、Sliding closure design for easy opening and closing mold assembly easy to change;
4、Fully hydraulic pressure.